• Modular clip-on compatible with the V2 shim
  • Sloped front to facilitate easy clipping in
  • Tough glass filled nylon

 

Description

The FORM stacker kit system is designed to extend the height of the V2 walkable MTB shim to accommodate stack height requirements above the standard 3-6mm range. The kit replaces the standard 2mm stacker that comes with the shim with an extended height stacker PLUS an optional additional 2mm clip-on spacer set.

  • Kit 1 will provide between 7-10mm when combined with the base 3mm shim and 1mm spacer.
  • Kit 2 will provide between 11-14mm when combined with the base 3mm shim and 1mm spacer

Due to the size necessary to provide sufficient stability for a taller stack this stacker requires a "clean" flat surface front to rear without any raised rubber areas. In the case of raised rubber areas there are ways to get round the problem, however a flat surface is best. Please contact us with any queries about this.

The 4/6mm stacker measures:

  • 70mm front to rear
  • 35mm from the cleat bolt holes rearward
  • 48mm wide

The 8/10mm stacker measures:

  • 74mm front to rear
  • 35mm from the cleat bolt holes rearward
  • 48mm wide

Kit includes:

  • 4/6mm kit (7-10mm total): 4mm stacker / 2mm spacer set / cleat plate / shim screws / cleat screws
  • 8/10mm kit (11-14mm total): 8mm stacker / 2mm spacer set / cleat plate / shim screws / cleat screws

*Please note: This kit does not come with the shim itself, that needs to be purchased separately.